Free Shipping 12V/24V DMX Decoder & LED Driver 12 Channels LED RGB Controller DE 8012
2.256-levels brightness,full-color with driver controls
3.Output 12 channels,MAX 4A per channel.Total current is 48A.
4.Can achieve asynchronous color changes effect under working with controller.
5.Cooperate with control system, can realize rich change effect.
6.Setting the DMX address freely
7.Modularizing and can be matched with different LED module neatly.
Signal Input:DMX-512/1990 Digital signal
MAX Power: <1152W
Work Temp.:0~70degree Celsius
The light gray level: 256
Protection grade: IP40
Gross product: 460g Product size: L250*W130*H 24(mm)
1.Drive output interface is altogether anode drive, has eight V + interfaces and 12 channel R, G, B output interfaces, can meet all kinds of full color module and monochrome module automatically according to the lamps module load adjust the output current, each channel maximum must not over 4A.
Note: The anode connection full-color module can be directly put the positive line and R, G, B line connected to the decoder output interface corresponding foot position; Monochromatic module can put the positive line to the decoder’s output interface V + feet, negative line according to the color of the module connected to the decoder output interface R, G, B a foot position; A few kinds of color of monochromatic module connect to the same decoder, must put their positive line to the decoder output interface V + feet.
2.With self test procedures, the model of all lighting DIAL NEEDLE,put the dial switch 1 to 9 up and the lights are lighting.
RGB channel gradient mode DIAL NEEDLE put the dial switch 1 to 9 down, it’s channel gradient mode.
DMX-512 Control signal connection
1.DMX signal cable is made of twisted pair (line), DMX signal includes positive and negative end, in pressure welding DMX signal line plug should pay special attention to polarity. DMX512 controller input and output RJ45 interface: PIN1 is signal positive, PIN2 is signal negative, PIN7.8 is signal ground, please corresponding polarityconnection.
2.DMX5000 output and DE8012’s transmission lines can’t be over 300 meters.
3.DMX5000 each interface can with not more than 170 pieces of DE8012. Eight output interface. Through the JBLED FLASH light making software and can with computer on line control. Realize infinite connect the DMX lights.
4.When contacting 32 pieces of DE8012, DMX signal must add a signal amplifier RE2000 . Cascade can’t more than 4 PCS.
5.At the end of the connection, we should connect a DMX signal finalizer ( Put down the code switch no.10 of DE8012 dial).